ABB REL300 Instruction Manual page 119

I.L. 40-385.7
TABLE 4-4. RECOMMENDED JUMPER POSITIONS (V2.2X)
OUTER CHASSIS
An External jumper between FT-Switch 13 and 14 of 2FT-14 should be connected permanently.
(Refer to terminals 2 & 4 of 2 FT-14 on Figure 4-3.)
INTERCONNECT Module
JMP 1 to 6, & 13
JMP 7 & 9
JMP 8 & 10
JMP 11 & 12
MICROPROCESSOR Module
JUMPER
JMP 1
JMP 2
JMP 2
JMP 3
JMP 3
JMP 4
JMP 5
JMP 6
JMP 8 & 9
JMP 10, 11 & 12
Note * : JMP1, 8 and 9 were removed for module with sub 5 or higher.
POWER SUPPLY Module
JMP1
JMP2
CONTACT Module (Optional)
JMP1
JMP2
JMP3
JMP4
4-22
For the rated input dc voltage
For Stub Bus Protection
For the trip alarm (AL2-2)
For REL300 with FT switches only
POSITION
1-2 *
2-3
1-2
OUT
IN
OUT
OUT
OUT
1-2 *
IN/OUT
1-2 Carrier Stop
2-3 Carrier Stop
1-2 Carrier Send
2-3 Carrier Send
NO OC-5 Contact, NO
NC OC-5 Contact, NC
NO OC-6 Contact, NO
NC OC-6 Contact, NC
NO OC-7 Contact, NO
NC OC-7 Contact, NC
NO OC-8 Contact, NO
NC OC-8 Contact, NC
FUNCTION
EEPROM (8kx8)
Single-pole trip option
Three pole trip or Programmable
contact outputs
Standard for Rotation ABC
Rotation ACB
No dropout time delay for trip contacts
Disable output contact test
Normal operation
RAM (32kx8)
Spare jumpers
NO
NC
NO
NC