AEG BN071436DH User Manual page 22

22 www.aeg.com
Problem
The sensor fields become
hot.
comes on.
comes on.
comes on.
and a number come on.
comes on.
There is no spark when you
try to activate the spark gen‐
erator.
Possible cause
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on the
zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
There is an error in the hob.
There is an error in the hob
because a cookware boiled
dry. Automatic Switch Off
and the overheating protec‐
tion for the zones operate.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Remedy
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical data"
chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
Deactivate the hob. Remove
the hot cookware. After ap‐
proximately 30 seconds, ac‐
tivate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware
become sufficiently cool.
Check if your cookware is
compatible with the hob.
Refer to "Hints and tips"
chapter.
Check if the hob is correctly
connected to the electrical
supply.