HYOSUNG MONiMAX5100T Operator's Manual page 22

Chapter3. For the beginning operator
► Changing Your Battery
3-2
<Note!>
If battery is depleted and will not allow lock to open, follow instructions below.
Lock contains a non-volatile memory, even with batteries removed the lock will retain
all programming.
1. Slide the keypad housing up and carefully pull away from mounting surface to expose
battery compartment.
2. Remove the old 9-Volt alkaline battery.
3. Remove the connector by unsnapping it from the two terminals on the top of the
battery.
4. Replace with NEW 9-Volt alkaline battery.
<CAUTION>
Hold onto battery terminal connector to avoid pulling the wires out of housing
5. Carefully position the keypad over the mounting screws and slide the keypad
Housing down. Ensure there are no wires or cables trapped between the input pad
and the safe door. Pinched cables can result in a short circuit.
© Hyosung TNS Inc. All Rights Reserved.
Operator Manual