Table of Contents
Advertisement
Operator Manual
Chapter3. For the beginning operator
Locking Device
Electronic Lock
► Opening Electronic Lock
► Wrong Try Penalty
1. Entry of four (4) consecutive invalid combinations starts a five (5) minute delay
2. At the end of the delay period, two (2) more consecutive invalid combinations will
► How to change the electronic lock combination
► Battery Low Warning
1. The default combination for Electronic Lock is 1-2-3-4-5-6. Enter this sequence on
the electronic lock keypad. The lock will confirm a valid combination entry with a
double signal. Lock will signal three (3) times for invalid combination entry.
2. Turn the vault door handle counterclockwise. The vault door will open.
period.
▪ LED lashed red at ten (10) second intervals.
restart the additional five (5) minute delay period.
<Note!>
Entry will not respond to keystrokes during delay period.
Always perform this operation with the door open.
1. Enter 0-0-0-0-0-0, six (6) zeros, into the Electronic Lock keypad.
2. Enter in the old combination once.
3. Enter in the new combination twice. Combinations must be six digits in length.
4. If a mistake is made wait thirty (30) seconds and repeat steps 1-3.
5. Test lock operation several times before closing the door.
<CAUTION>
When selecting a combination do not use birthday or other predictable data that could
give correlation between the user and combination.
<Note!>
The Electronic Lock will signal three (3) times if the new combination is invalid and the
old combination has been retained.
1. Repeated LED flashing and beeping during an opening indicates that the battery is
low and needs immediate replacement.
2. Uses one (1) 9-Volt alkaline battery only. (Example: Duracell™ or Eveready™
alkaline batteries.) The replacement of batteries at least once annually is
recommended.
© Hyosung TNS Inc. All Rights Reserved.
Chapter3. For the beginning operator
3-1
Advertisement
Table of Contents
