Savari MW-1000 User Manual page 43

21. How do I connect to MW-1000 from my Windows PC?
Please follow the instructions listed below to connect to your MW-1000 board.

Open Putty application.
Check out '9.1.2 Putty – Connecting to MW-1000 terminal' section for
installation/usage instructions.

Provide MW-1000's IP-address and port-number in Putty configuration section.

Select "Yes" button in the popup. In case if you get a security prompt (popup) in putty -
stating certificate is not verified.

Enter username in the shell (putty-cmd)

Enter password in the shell (putty-cmd)
On entering correct user-credentials, MW-1000 accepts the connection request, and you can
access MW-1000 command-line-interface (CLI)
22. What is my board's IP address/subnet?
By default, Once your MW-1000 is assigned an IP address of 192.168.100.1 (subnet
192.168.100.*). In case, if the IP-address is updated (or) if you are not able to view the MW-
1000 on its default IP-address. Follow the instructions listed for identifying the new-IP-address.

Connect your (Linux) PC using a serial cable to management port on MW-1000.

Open terminal on your (Linux) PC.

Use the minicom command to access MW-1000 via serial-port. (in Linux environment)
> minicom
In windows environment, use putty to connect via serial port. For putty-configuration
details, refer to '9.1.2 Putty – Connecting to MW-1000 terminal' section.

Enter the username and password for entering MW-1000.

Once you are logged-into the MW-1000, enter the following command for identifying
the IP-address.
> ifconfig eth0
Check-out the value for 'inet addr'. ex: 'inet addr:10.0.0.191'
23. Where can I find my USB drive files?
Please refer to section ' USB' for details on mounting location.
24. How to mount/unmount USB?
Refer to section 7 'Command Line Interface Commands' for mount/unmount commands.
25. How do I connect to MW-1000 from my Linux PC?
In case Board is inaccessible post reboot, connect to MW-1000 using either a microUSB cable or
via serial-cable (to management port)
Follow the instructions mentioned below to recover from failure:

Connect microUSB cable to console port of MW-1000.
Refer to section 9.2.2 'Connecting to MW-1000 via microUSB port'

Check & update DHCP configuration in network file at /etc/config/network

Initiate DHCP process by executing "udhcpc" in terminal
> udhcpc
MW-1000™ User Guide
39