Leds; Ethernet; Usb; Wifi - Savari MW-1000 User Manual

3.8

LEDs

MW-1000™
comes with the following three LEDs on the panel to indicate the following:

Power

BSM Transmission (Tx)

Diagnostics (currently used to indicate USB drive mounted/unmounted status)
3.9

Ethernet

MW-1000™
consists of one Ethernet port (eth0) on the panel

3.10 USB

MW-1000™
supports USB drive, and it is mounted in the following location-
/mnt/usbdrive
MW-1000™
Note: By default,
drive.

3.11 WiFi

It provides WiFi capability in 2.4 GHz and 5GHz band. By default, configured for 2.4 GHz. It is
used for HMI connection and maintenance purpose.
By default, when the board comes up, the process will be started as below.
2081 root 3304 S
Any changes done in this file can be applied by restarting savari-hmi.
/etc/init.d/savari-hmi stop
/etc/init.d/savari-hmi start
devices do not log the CML and SML messages in the USB
/usr/local/bin/hostapd -B /etc/config/hostapd-minimal.conf
8
MW-1000™ User Guide
.