Advanced Configurations - Network; Ip Address Configuration - Savari MW-1000 User Manual

SPATMAPPsid
TIMPsid
SPATMAPBypassSecurity
SPATMAPSecurityEnabled
Vehicle configurations.
VehicleWidth
VehicleLength
VehicleHeight
VehicleType
6.2

Advanced Configurations - Network

IP Address configuration

The IP address configuration is available in the following file:
/etc/config/network
A sample format of the file is explained below. A single IPv4 address and up to three IPv6
addresses (ipv6addr1, ipv6addr2, and ipv6addr3 options) can be specified per interface.
Loopback Configuration:
Configuration Item
config interface loopback
identical to the application, which run on the same
interface.
0x00 0xEFFFFFFF # PSID that should be used when
(Default: receiving PSIDPSID Length: Valid Values
0x8002) 1 byte: 00 - 7F
2 bytes: 8000 – BFFF
3 bytes: C00000 – DFFFFF
4 bytes: E0000000 – EFFFFFFF
0x00 0xEFFFFFFF # PSID that should be used when
(Default: receiving PSIDPSID Length: Valid Values
0x8003) 1 byte: 00 - 7F
2 bytes: 8000 – BFFF
3 bytes: C00000 – DFFFFF
4 bytes: E0000000 - EFFFFFFF
0, 1 Enable/Disable Security verification bypass
(Default: 1)
0, 1 0 – Disable
(Default:1) 1 – Enable
File-path: /etc/config/v2vi_obe.conf
0, 10.23 Vehicle width in meters.
(Default: 2)
0, 40.95 Vehicle length in meters.
(Default: 5)
0, 6.35 Vehicle height in meters.
(Default: 1.5)
0,15 As per J2735
(Default: 4)
Value
15
MW-1000™ User Guide
Description
Network name