Concord Camera Eye-Q 3X Instruction Manual page 23

TROUBLESHOOTING GUIDE (CONTINUED)
SYMPTOM
Flash picture
taken is too dark.
Daylight picture
taken is too dark.
Can't take
picture.
Flash did not
work.
Can't take
picture.
POSSIBLE
CAUSE
Subject is too far away.
Flash is not on.
The subject is in front of
bright light.
Memory is full.
Power is off.
There was sufficient light
for the shot, flash was
not needed.
Flash is not on.
Flash did not charge
fully.
Battery is empty.
Unit is not set to
Camera mode.
POSSIBLE
SOLUTION
Move subject closer.
Turn flash on.
Change the subject's
position.
Delete unwanted pictures
and continue shooting, or
download all pictures to
the PC and then delete all
pictures from camera
memory (see Reviewing/
Deleting Pictures).
Turn power on.
This is normal as your camera's
electronic light sensor is
programmed to only fire
the flash when needed.
Turn flash on.
Press The shutter/camera/
review button and verify
that the LED has stopped
blinking before taking the
picture.
Replace the battery.
Set the unit to Camera
mode.
23