Grundfos CREC Installation And Operating Instructions Manual page 30

2. Remove the terminal box cover.
Fig. 40 Removing the terminal box cover
3. Press and hold in the two locking tabs (A) while
gently lifting the plastic cover (B).
Fig. 41 Lifting the plastic cover
4. Turn the plastic cover 180 °.
Do not twist the cable more than 90 °.
Fig. 42 Turning the plastic cover
30
5. Position the plastic cover correctly on the four
rubber pins (C). Make sure that the locking tabs
(A) are placed correctly.
Fig. 43 Positioning the plastic cover
6. Fit the terminal box cover, and make sure that it
is also turned 180 ° so that the buttons on the
operating panel are aligned with the buttons on
the plastic cover.
7. Tighten the four screws (TX25) with 5 Nm.
Fig. 44 Fitting the terminal box cover