Yamaha TW125 2003 Supplementary Service Manual page 13

C Clamp the wire harness, handle-
bar switch lead (right), front
brake light switch lead, clutch
switch lead, main switch lead,
resonator hose and
cable.
D Clamp the ignition coil lead and
the ignition coil grand lead horn
lead.
E Route the wire harness, handle-
bar switch lead (right) and front
brake light switch lead through
the guide.
F Do not bend the lead sharply just
after the terminal connection.
G Point the rear brake light switch
lead to the rear side of the ve-
starter hicle.
H Route the lead by the front side
of the sheet pillar tube so that it is
not be caught between the side
cover flange and the frame sheet
pillar tube.
–5–
CABLE ROUTING
I Secure the rear brake switch,
knob-shape part of the lead, car-
buretor heater lead and turn sig-
nal relay lead. At this time, make
sure to secure the turn signal
relay lead at the outmost posi-
tion. Next, point the surplus part
of the band to the inner side and
then cut it.
J Relay lead can be routed either
the front or the rear side of the
relay.
SPEC