Hazards Caused By Accessories; Hazards In The Workplace - Parkside PDAP 75 A1 Translation Of The Original Instructions

Hazards caused by accessories

■ Disconnect the sander or the polisher from the power before
changing the tools or accessories .
■ Avoid direct contact with the machine tool during and after use,
since this can have heated up or have become sharp .
■ Use only tools for sanders and polishers which have been ap-
proved by the manufacturer of the sander and polisher .
■ Cutting discs and machines for cutting may not be used .
■ Check whether the maximum operating speed of the tool
(stitched buffs, abrasive belts, fibre discs, etc .) is higher than that
of the machine;
■ Self-adhesive grinding discs must be applied concentrically on
the mounting plate .

Hazards in the workplace

■ Slipping, tripping up and falling are the main causes of injuries
in the workplace. Take note of surfaces which could have be-
come slippery through use of the machine, and also any tripping
hazards caused by air or hydraulic hoses .
■ These sanders and polishers are not suitable for use in explosive
environments and are not insulated against contact with power
sources .
■ Do not operate the appliance in the vicinity of electric mains,
gas pipelines etc . which could pose a hazard if damaged by the
machine .
PDAP 75 A1 GB │ MT │ 87 ■