General Safety Instructions; Correct Purpose Of Use; Incorrect Purpose Of Use - Häfele 633.25.006 Translation Of The Original Operating Instructions

1.1 General safety
instructions
1.2 Correct purpose of
use
1.3 Incorrect purpose
of use
16
The following safety instructions must be observed during operation in
order to prevent hazards.
Safety instructions pertaining to operation
> The lift must only be installed by experts.
> Children may only use the lift if they are being supervised by an adult.
> Do not attach any additional objects or support yourself on the lift.
> Disconnect the lift from the power supply immediately and contact the
manufacturer in the event of damage, smoke development or the occur-
rence of unusual noises or odours.
> Do not install any heat sources in the vicinity of the lift (candles, heaters,
etc.).
Electrical safety
> Do not allow liquids to penetrate the control unit (e.g. spillage from
containers containing liquids onto the worktop).
> Do not open the housing of the control unit.
> Always pull out the mains plug when disconnecting from the power supply.
> Do not connect any distributors or adapters between the equipment and the
power supply.
> Never replace or modify the mains plugs / mains leads.
The lift is designed for the following purposes:
• Vertical raising and lowering of a furniture item (worktop, sink, hot plate unit etc.).
The lift may be installed and used in the following environments:
• On the rear panels of suitable and sufficiently load-bearing furniture items (see
"2.4 Installation requirements / Technical data"),
• In dry interior rooms in compliance with the limits of the product defined by the
technical data (see "2.4 Installation requirements / Technical data").
Do not install/use the lift in the following environments:
• Potentially explosive or aggressive environments,
• Near hot surfaces, heat sources (candles, heaters etc.),
• Areas that are exposed to direct sunlight for long periods. Panelling made from
stainless steel can heat up.
It is particularly important to avoid the following:
• Continuous use and overloading. The lift must not be used for more than
2 minutes at a time with a full load, after which it should not be used again for
18 minutes. The control unit switches off if the lift is overloaded.
• Installation and use of damaged or non-original components.
• Use of the control unit to power other devices.
• Omission of components during assembly.
• Conversion, maintenance or repair work on the lift.