NOTE: The grill is upside-down during this
assembly step.
Assemble the CONSOLE CASTINGS.
Step
2
Use a large piece of cardboard or a ground
cloth to protect the painted finish on the
castings.
Lay all three castings on a level surface with
the top (smooth) surface downward.
2-A
Left Console Casting
Center Console Casting
Right Console Casting
2-A. Lay all three castings on a level surface with the smooth
(top) surface downward.
Hardware shown actual size
(MG)
1/4-20 x 7/8 Hex Head Cap Screw
(8) Qty.
Hardware
shown actual
size
(NH)
Clip
(2) Qty.
2-B. Assemble the Right Console Casting to the Center Console Casting. Three Alignment Pins
mate with three Alignment Holes in castings. Fasten with four SCREWS (MG) and four HEX
(BV)
NUTS (BV) and one Clip (NH). See Detail 2-C and Detail 2-D for location of Clip (NH).
1/4-20 Hex Nut
Tighten the fasteners.
(8) Qty.
Repeat Step 2-B to assemble the Left Console Casting to the Center Console Casting.
NH
2-C
2-B
MG
NH
BV
MG
Alignment Pin
Alignment Hole
Another
NH
View of
2-D
Clip (NH)
Right Console Casting
BV
MG
BV
MG
BV
(Pg. 4)