Greenlee IntelliBENDER 855GX Instruction Manual page 17

Operation (cont'd)
BendWorks™ Software Troubleshooting
Process Errors
1 Bend Length Plus Head Tail
Exceeds Default Nominal
Length
Bend Radius Too Big
2
3 Bend Spans Multiple Segments ErrorCode.BendSpansMultipleSegments, 4
Concentric And Normal Bend
4
5 Concentric Bend Radius Too
Small
45 Conduit Length Too Small
Between Bends
Segment Has More Than 5
6
Bends
7 Short Segment Length
Total Segment Length Exceeds
8
Default Nominal Length
Warning Errors
23 Mark Prefix Used
24 Total Angle Of Bends Exceed
360
25 Total Angle Of Bends Exceeds
Max Total Angle
26 Total Length Of Conduit Run
Exceeds Max
Greenlee Tools, Inc.
Error Code
ErrorCode.
BendLengthPlusHeadTailExceedsDefaultNominalLength, 1
ErrorCode.BendRadiusTooBig, 2
ErrorCode.ConcentricAndNormalBend, 8
ErrorCode.ConcentricBendRadiusTooSmall, 16
ErrorCode.ConduitLengthTooSmallBetweenBends,
17592186044416
ErrorCode.SegmentHasMoreThan5Bends, 32
ErrorCode.ShortSegmentLength, 64
ErrorCode.TotalSegmentLengthExceedsDefaultNominalLength,
128
ErrorCode.MarkPrefixUsed, 4194304
ErrorCode.TotalAngleOfBendsExceed360, 8388608
ErrorCode.TotalAngleOfBendsExceedsMaxTotalAngle, 16777216
ErrorCode.TotalLengthOfConduitRunExceedsMax, 33554432
17
855GX Electric Bender
Length of Bend + D + X + Tail
cannot be greater than default
nominal length.
Bend radius cannot be too big.
A bend cannot span multiple
segments of conduit.
Cannot have concentric/segment
bend and normal bend in the same
conduit.
The concentric bend radius cannot
be too small.
The conduit length between two
bends cannot be less than coupling
length.
A segment of conduits cannot
have more than 5 bends with the
exception of concentric arcs.
Conduit shorter than preferred
minimum length.
The conduit run length exceeds the
default nominal length.
The mark prefix has been used.
Total bend angles exceed 360
degrees.
Total bend angles exceed
maximum allowed bend angle.
Total length of conduit run exceeds
the maximum allowed length.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Explanation of Error
Explanation of Error