Greenlee 800 Operating Safety And Servicing Instructions

Hydraulic cable bender

Table of Contents

Download this manual

OPERATING SAFETY AND

SERVICING INSTRUCTIONS

800

HYDRAULIC CABLE BENDER

350 MCM through 1000 MCM

(253mm

thru 507mm

)

Read and understand this material before

operating or servicing this bender. Failure to

understand how to safely operate the bender

could result in an accident causing serious

injury or death. This tool should only be

operated by qualified personnel.

For Additional Copies of This Instruction Manual, At No Cost, Call or Write:

Greenlee Tools, Inc.

4455 Boeing Drive, Rockford, IL 61109 USA

800/435-0786, in Illinois call 815/397-7070

Telex: 4330029 GTCRKD, Fax: 815/435-2932

Service: 800/435-2932, Canada: 800/233-5924

999 5542.3

IM-924 REV 4

9/19

Table of Contents

Need help?

Do you have a question about the 800 and is the answer not in the manual?

Page 1 For Additional Copies of This Instruction Manual, At No Cost, Call or Write: Greenlee Tools, Inc. 4455 Boeing Drive, Rockford, IL 61109 USA 800/435-0786, in Illinois call 815/397-7070 Telex: 4330029 GTCRKD, Fax: 815/435-2932 Service: 800/435-2932, Canada: 800/233-5924 999 5542.3 ©...
Page 2 I. INTRODUCTION III. SAFETY ALERT SYMBOL The Greenlee 800 Hydraulic Cable Bender is a ® lightweight, portable tool for on-the-job bending of standard copper and alumnium cable from 350 MCM The symbol above is used to call your attention to to 1000 MCM.
Page 3 • This tool may be used on cable sizes ranging from 350 MCM thru 1000 MCM. Hydraulic Pressure: 6500 p.s.i. maximum pressure • The 800 Cable Bender is designed to be used with the Greenlee 1725 Hydraulic Foot Pump and 767 Bend: One shot bends up to 90°...
Page 4 800 HYDRAULIC CABLE BENDER PARTS LIST NO. 800 HYDRAULIC CABLE BENDER Order By This When Ordering Parts Give Number Only Serial Number of Unit CONTROL NO. DESCRIPTION QTY. 502 3909.0 Drive Shoe 502 3911.2 Rotating Shoe 502 3913.9 Link 502 3915.5 Cylinder Pivot Block 502 9100.9...