Bending Instructions - Greenlee IntelliBENDER 855GX Instruction Manual

Bending Instructions

90° STUBS
1. Measure the length of the required stub.
2. Refer to the Minimum Stub Length formula on the
Deduct Table. The required stub must be equal to or
longer than the Minimum Stub Length.
3. Measure and mark the stub length on the conduit.
This is Mark 1. Subtract the Deduct from this mark
and make a new mark. This is Mark 2.
4. Align Mark 2 with the front edge of the hook and
bend the conduit.
Note: The shoe bends to 90° maximum.
STUB LENGTH
MARK 2
DEDUCT
Greenlee Tools, Inc.
MARK 1
MARK 2
855GX Electric Bender
Deduct Table
CONDUIT SIZE
STEEL RIGID
EMT
DEDUCT
IMC
ALUM. RIGID
MINIMUM STUB LENGTH = DEDUCT PLUS 2 INCHES
Figures are approximate
21
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
1 1-1/4 1-1/2
11-7/8 14-3/8 15-3/8
11-7/8 14-3/8 15-3/8
11-7/8 14-3/8 15-3/8
11-7/8 14-3/8 15-3/8
2
16-5/8
16-7/8
16-5/8
16-5/8