Seasoning Your Grill - Traeger TFB29KLF Owner's Manual

SEASONING YOUR GRILL

TO BE USED ON INITIAL FIRING ONLY.
first, to prime the auger ("charge" the auger tube with pellets) and, second, to season your grill (run your grill at a high temperature).
1
Remove the porcelain-coated grill grate, grease drip tray,
and heat baffle from the inside of the grill.
3
NOTE:
Once you turn on your grill, it will enter Idle
mode, and the display's dashed border will pulse. This
indicates your grill is awaiting a command, and is not
actively operating. The grill MUST be in Idle mode to
prime the auger.
In order to ensure proper and safe operation of the grill, follow the instructions below,
2
PLUG APPEARANCE MAY VARY BY REGION.
(GFCI) protection must be provided on the circuit or
outlet used to power the grill.
With the Main Power switch on the back of the grill
hopper in the OFF (O) position, plug the power cord into
an appropriate grounded/earthed GFCI electrical outlet.
4
Open the hopper lid. Make sure there are no foreign
objects in the auger before adding pellets to the hopper.
With the grill in Idle mode, press and hold the "Up" and
IGNITE buttons simultaneously. The display will flash "Pri"
and the auger will begin priming.
13
WARNING!
Ground Fault Circuit Interrupter
TRAEGERGRILLS.COM