Operation - Kärcher RCW 5 Manual

The cleaning robot can emit light and sound signals to
indicate various operating states, critical situations and
fault codes.
LED
LED battery status, when
charging
LED device status, clean-
ing robot in the station
LED battery status, in op-
eration
LED device status, when
attaching to a glass sur-
face
LED device status, in oper-
ation
®
Bluetooth status LED
Preparing the glass surface
1. Before using the cleaning robot, make sure that no
objects protrude into the movement space of the
cleaning robot, which could hinder its movement.
Illustration J
Obstacles can be, for example:

Operation

Light and sound signals
Signal
Flashes green
2 s on / 2 s off
Lights up green
Indicator tone at the end of
the charging process
Flashes red
0.5 s on / 0.5 s off
Flashes green
2 s on / 2 s off
Lights up green
Indicator tone at the end of
the filling process
Flashes red 1 s on / 3 s off ● Tank empty.
Lights up green
Lights up red
Flashes red
Warning tone every 10 s
Flashes green
Lights up green
Flashes red
1 s on / 1 s off
Lights up green
Flashes green
2 s on / 2 s off
Reminder tone every
5 min
Flashes red
Warning tone every 10 s
Flashing green, right / left
alternating
Cleaning finished indicator
tone
Off
Flashing blue
Lights up blue
An fault code table can be found in chapter: Trouble-
shooting guide
Description, notes
● Battery is being charged.
● Battery fully charged, cleaning robot ready for use.
● Fault during charging.
(For remedies, see chapter: Troubleshooting guide)
● The cleaning robot detergent container is being filled.
● Detergent container completely filled.
(For remedies, see chapter: Troubleshooting guide)
● Battery fully charged, cleaning robot ready for use.
● Battery almost discharged, place the cleaning robot in the
station to recharge after completion of the current clean-
ing process.
● Battery is discharged, remove the cleaning robot from the
glass surface immediately and place it in the station for
charging.
● Cleaning robot suctions onto the glass surface.
● Cleaning robot suctioned properly.
● Cleaning robot NOT suctioned properly, remove the
cleaning robot from the glass surface immediately. Clean
the suction cups and the main seal and check the main
seal for correct seating in the mount. Attach the cleaning
robot again.
● Cleaning robot active.
● Pause activated. Press the On / Off button to continue the
cleaning process.
● Battery is discharged, remove the cleaning robot from the
glass surface immediately and place it in the station for
charging.
● Cleaning finished. Cleaning robot moves to its original po-
sition. Remove the cleaning robot from the glass surface.
®
● No bluetooth -Active connection.
● Waiting for confirmation: Briefly press the On / Off button.
®
● Bluetooth -Active connection.
● Curtains and drapes
● Objects on windowsills
● Window pictures and stickers
English 21