Table of Contents
Advertisement
2. Start-Up
To carry out a test first switch on the machine by pressing and holding the green "on" button, located
on the right-hand side of the unit, for approximately 3 seconds.
A splash screen will be displayed which shows the
instruments hardware and firmware versions.
Periodically the firmware is upgraded as part of
the recalibration process as improvements are
identified.
A Stylus pen is provided for use with the touch
screen. The display will show the, date last
calibrated, serial number and a tick or cross
symbol will indicate whether it is within the
recommended calibration period.
Press the arrow key to progress to the main menu.
The main menu has 3 options available from left to
right these are:
Begin test, Review Previous Tests and Set-Up
Menu.
Each of these sub-menus are described in further
detail below
The instrument can also be turned off from this
menu by pressing the red power symbol in the top
right hand corner.
Note – If the begin test icon is in grey this will be
because the instrument's memory is full (20 tests
maximum) and you need to remove at least 1 test
before you can proceed. See Section 4 – Reviewing
Test Results for further details.
5
Advertisement
Table of Contents
