Pre Use - Factair F6001 Operating Manual

Equipment List:
F6001 Safe-Air Tester
Hard Case
Mains Power Supply
USB Download Cable
6 x AA Alkaline Batteries
F3002 High-Pressure Regulator
Stylus Pen
Optional Extras
TUB0053 – 8103560 Draeger Oil Impactor – Box of 10
F1946 Connection ¼ BSP inlet adaptor
F2193 Safe-air Tester to Draeger/Scott compatible plug adaptor
F2194 Connection adaptor terminating in a Rectus Plug
F2195 Connection adaptor terminating in an Instantair Plug
1. Pre-Use
Testers are supplied with 6 off, size AA, alkaline type batteries packed separately and stored
underneath the tester within the case. Please note rechargeable batteries are not suitable for use with
this instrument.
Batteries must be installed prior to use unless it is the intention to power the unit solely from a mains
supply. To install the batteries lift the tester out of its case, open the battery drawer at the front of the
unit and place the batteries inside.
Note: - It is important to strictly observe polarity when fitting batteries and ensure that they are correctly
located.
If on start up the battery level is too low a warning will be displayed on the screen; the test cannot
continue until the batteries are replaced or the unit is operated from the mains power supply. During
use the battery condition is displayed on the screen.
If the Tester is to be used adjacent to a power socket, the mains adaptor may be used. Please note the
unit should be switched off prior to connection or disconnection of the mains supply.
4