Setup And Configuration (Display Models); Unloading The Thermal Transfer Assembly - Datamax M-Class Mark II Quick Start Manual

Thermal transfer option

Hide thumbs Also See for M-Class Mark II:

Table of Contents

Setup and Configuration (display models)

In order to use thermal transfer printing the 'Media Type' menu function must be set to 'Ribbon

Transfer'. Follow the steps below to set the printer to 'Thermal Transfer'.



Note:

The DMXConfig Utility can also be used to change the Media Type setting. For more

information see the previous section "Setup and Configuration (non-display models)"



Note:

During this procedure, consult the Operator's Manual for detailed front panel instructions.

Configure the printer for the thermal transfer use as follows:

 Plug the power cord into the AC Receptacle and turn 'On' the Power Switch.

 Press the MENU Button on the printer's front panel.

 Press the ENTER Key to select MEDIA SETTINGS, and press the key again to select MEDIA TYPE.

 Using the DOWN Button, scroll to THERMAL TRANSFER then press the ENTER Key.

 Press the EXIT Key and then, at the SAVE CHANGES? prompt, press the YES Key.

When the ribbon supply has been emptied, simply pull the cardboard core off the Supply Hub. To remove

the used ribbon, grasp the ribbon and pull it from the Take-Up Hub.

Table of Contents

Do you have a question about the M-Class Mark II and is the answer not in the manual?