Zanussi ZPHNL3W1 User Manual page 21

Step 3 Pull the rear end of the shelf
support away from the side wall
and remove it.
Step 4 Install the shelf supports in the
opposite sequence.
HOW TO REMOVE AND INSTALL: DOOR
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
WARNING! The door is heavy.
Step 1 Fully open the door.
Step 2 Lift and press the clamping
levers (A) on the two door
hinges.
Step 3 Close the oven door to the first
opening position (approximate-
ly 45° angle). Hold the door
with one hand on each side
and pull it away from the oven
at an upwards angle. Put the
door with the outer side down
on a soft cloth on a stable sur-
face.
Step 4 Hold the door trim (B) on the
top edge of the door at the
two sides and push inwards to
release the clip seal.
Step 5 Pull the door trim to the front
to remove it.
Step 6 Hold the door glass panels on
their top edge one by one and
pull them up out of the guide.
1
2
CAUTION! Carefully handle the glass,
especially around the edges of the
front panel. The glass can break.
A
45°
2
B
A
1
21