Advertisement
A
B
part
A
Welded Basket Assembly
B
Clamp Plates
C
Threaded Knob
D
Machine Screw
E
U-Bolt
F
Bar Saddle
G
Wind Deflector
H
Screw
I
Plastic Washer
J
Allen Key
• Thoroughly read instructions and guidelines before
attempting to install and use your cargo basket.
• Do not exceed the weight capacity of your vehicle's
rack system.
• Your carrying weight is the combined weight of the
basket and its contents (Basket weight = 35lbs.).
• Where possible, position the vehicle's load bars
towards the back of the vehicle. This will help
with fuel efficiency and wind noise.
• Check SportRack's Fit Guide for approved fits
on factory installed racks.
• Secure loads with SportRack's cargo net (SR9031,
sold separately).
501-5995_01
ROOF BASKET - SR9035
PARTS INCLUDED
D
C
description
WARNINGS / LIMITATIONS
E
F
G
H
I
part number
—
—
—
—
—
—
—
—
—
—
J
qty.
2
4
11
4
4
4
1
3
3
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SportRack SR9035
Summary of Contents for SportRack SR9035
- Page 1 • Where possible, position the vehicle’s load bars towards the back of the vehicle. This will help with fuel efficiency and wind noise. • Check SportRack’s Fit Guide for approved fits on factory installed racks. • Secure loads with SportRack’s cargo net (SR9031, sold separately).
- Page 2 • Slide the two halves of the basket (A) together. Align the holes in the bottom and top tubes and install screws (D) on both sides using the allen key (J). Top view • Install wind deflector (G) using screws (H), plastic washers (I) and knobs (C) as shown. 501-5995_01...
- Page 3 • Put the basket on the factory or aftermarket crossbars to determine where the bar saddles (F) are to be located. For optimal support on the rack, place the bar saddles as close to the ends of your crossbars as possible. The diagram at left shows the attachment area shaded in gray.
- Page 4 Threaded Knob (C) Clamp Plate (B) Bar Saddle (F) • Attach to crossbars by placing u-bolt (E) under the crossbar and up through the bar saddle (F). Slip the clamp plate (B) over the threaded ends of the u-bolt. Clamp plate must rest on the top of the basket rail.
Need help?
Do you have a question about the SR9035 and is the answer not in the manual?
Questions and answers