LifeGear 63144 Owner's Manual page 34

STEP 11-1
A. Thread the Cable (32) through the Leg Lever (16). Slot the Pulley (46) into the Leg
Lever (16) and pull the Cable (32) through over the Pulley (46). Then secure the
Pulley (46) into the Leg Lever (16) with one Hexagon Head Bolt (76), one Nylon Nut (85),
and two Flat Washers (87). Tighten bolt and nylon nut with one 14 mm-17 mm Double
Open End Wrench and one 17 mm-19 mm Double Open End Wrench provided.
B. Pull the Cable (32) forwards to the Upright Tube (6). Slot the Pulley (46) in the Upright
Tube (6) and pull the Cable (32) through underneath the Pulley (46). Then secure the
Pulley (46) in the Upright Tube (6) with one Hexagon Head Bolt (75) and one Nylon
Nut (85). Tighten bolt and nylon nut with one 14 mm-17 mm Double Open End Wrench
and one 17 mm-19 mm Double Open End Wrench provided.
C. Pull the Cable (32) upwards to the Crossed Double Floating Pulley Bracket (23). Slot
the Pulley (46) in the Crossed Double Floating Pulley Bracket (23) and pull the Cable (32)
through over the Pulley (46). Then secure the Pulley (46) in the Crossed Double
17 mm-19 mm 14 mm-17 mm
33
14 mm-17 mm
17 mm-19 mm
17 mm-19 mm