Honda Pioneer SXS700M2P 2019 Owner's Manual page 234

If the Battery Is Low
1. To prevent an accidental short circuit, turn the ignition switch
OFF (w).
2. Remove the front seat (page 122) and right side rubber dust
cover.
3. Using a fully charged 12-volt battery, connect the positive (+) side
of the jumper cable to the charged battery, and connect the
positive (+) side on the other end of the jumper cable to the
positive (+) terminal of vehicle battery.
4. Connect the negative (-) side of the jumper cable to the charged
battery, and connect the negative (-) side on the other end of the
jumper cable to the front right door latch striker.
5. After starting the engine, remove the negative (-) sides of the
jumper cable from the vehicle and the battery. Then remove the
positive (+) sides of the jumper cable from the vehicle battery and
the charged battery.
6. Close the rubber dust cover and install the front seat.
• Do not let the positive (+) side of the jumper cable touch on the
negative (-) terminal.
• If the jumper cable is connected to the battery with the polarity
reversed, the battery can explode or the electrical system will
be seriously damaged.
UNDER SEAT
RIGHT SIDE
jumper
cable
charged battery
224 Taking Care of the Unexpected
right door latch striker
vehicle battery