Honda Pioneer SXS700M2P 2019 Owner's Manual page 146

Engine Oil & Filter
Add Engine Oil:
14. Remove the O-ring and sealing washer from the drain plug.
15. Install a new sealing washer onto the drain plug. Coat a new
drain plug O-ring with engine oil, and install it into the groove in
the drain plug.
16. Reinstall the drain plug, and tighten the drain plug to the
specified torque:
25 N·m (2.5 kgf·m, 18 lbf·ft)
17. Reinstall the maintenance lid by tightening the bolts to the
specified torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
18. Lower your Honda SXS safely.
19. Fill the crankcase with the recommended oil, approximately:
2.9 ℓ (3.1 US qt, 2.6 Imp qt)
20. Reinstall the oil fill cap and dipstick.
21. Start the engine and let it idle for 3 – 5 minutes.
22. Stop the engine and after 2 – 3 minutes, check the oil level. Make
sure the oil is between the upper and lower level marks on the
dipstick. If necessary, add more oil but do not overfill.
23. Reinstall the oil fill cap, dipstick and right and left rubber dust
covers.
24. Reinstall the front seat.
25. Check that there are no oil leaks.
If a torque wrench is not used for installation, see your dealer as
soon as possible to verify proper assembly.
UNDER BODY
drain plug sealing washer
drain plug O-ring
136 Servicing Your Honda