Honda Pioneer SXS700M2P 2019 Owner's Manual page 150

Rear Final Gear Oil
Changing Oil
Refer to Safety Precautions on page 105.
Change the oil with the rear final gear at normal operating
temperature to assure complete and rapid draining.
1. Park the Honda SXS on a firm, level surface.
2. Place an oil drain pan under the oil drain plug.
3. Remove the oil fill cap and the drain plug.
4. After the oil has completely drained, reinstall the drain plug with
a new sealing washer and tighten it to the specified torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
5. Fill the rear final gear with the recommended oil.
140 cm 3
6. Make sure the oil level is at the lower edge of the oil fill inspection
hole.
7. Apply a thin coat of grease to a new O-ring, and insert it into the
oil fill cap groove.
8. Install and tighten oil fill cap to the specified torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
9. Pour the drained oil into a suitable container and dispose of it in
an approved manner (page 202).
NOTICE
Improper disposal of drained fluids is harmful to the environment.
RIGHT REAR
oil fill cap O-ring
oil fill cap
oil drain plug
140 Servicing Your Honda
(4.7 US oz, 4.9 Imp oz)
lower edge of oil
fill inspection hole
sealing washer