IK UNO Synth Pro User Manual page 28

UNO Synth Pro
TRANSPOSE
You can transpose the entire keyboard +/- 12 semitones.
PITCH WHEEL
Adjust the Pitch Wheel range between 0 and 12 semitones
KNOB
UNO Synth Pro knob behavior uses "Absolute Mode" by default: this means that the knob value is recalled
using the absolute value of the position of the knob when edited (i.e.: turn a pot and the value jumps
immediately from the stored value to the edited value).
The other 2 modes are Pass-Through and Relative. In Pass-Through Mode, turning the knob has no effect until
after the edited value equals the preset value (or "passes through" the stored value).
In Relative Mode, the changes are relative to the stored setting and the full value range of the knob is not
available until either the minimum or maximum value and the respective lower or upper limit of the knob's travel
is reached.
METRONOME
"OFF", "ON", or "PLAY". OFF means the metronome is off in all situations. ON means the metronome is on and
hearable only when in real-time recording. PLAY means the metronome is always on, both in real-time recording
and in Playback.
The metronome is affected by the division chosen for a pattern.
CALIBRATE
UNO Synth Pro does a calibration and tuning of the oscillators each time it's turned on. From the Setup menu
you can start a calibration process for the oscillators.
OS UPDATE
Sets UNO Synth Pro in FW update mode. You can exit this stage only with a complete power circle,
disconnecting all the cables from the units.
28
5 – Global Controls