Operation - Zanussi ZFC627WAP User Manual

ing. To achieve sufficient ventilation follow
the instructions relevant to installation.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.

Operation

Switching on
Insert the plug into the wall socket.
The Pilot light will light up.
Turn the Temperature regulator clockwise.
Important! If the temperature inside the
appliance is too high the Alarm light will light
up.
Switching off
To turn off the appliance, turn the Temperature
regulator to the OFF position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator towards
obtain the minimum coldness.
• turn the Temperature regulator towards
obtain the maximum coldness.
14
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
to
• how often the lid is opened
• the quantity of food stored
to
• the location of the appliance.
are recyclable.
www.zanussi.com