Zanussi ZFC627WAP User Manual page 19

Problem
It is too cold inside the
freezer.
The appliance does not
work at all. Neither cooling
nor lighting works.
Customer Service
If your appliance is still not working properly af-
ter making the above checks, contact the near-
est service centre.
To obtain fast service, it is essential that when
you apply for it you specify the model and serial
number of your appliance which can be found
either on the guarantee certificate or on the rat-
ing plate located on the external right side of
the appliance.
Replacing the lamp
1. Disconnect the mains plug from the mains
socket.
www.zanussi.com
Possible cause
Large quantities of food to be fro-
zen were put in at the same time.
Food placed in the appliance was
too warm.
Products to be frozen are placed
too closely to each other.
The lid has been opened often.
The lid has been opened for a long
time.
The temperature is not set correct-
ly.
Plug is not connected to the mains
socket properly.
Power does not reach the appli-
ance.
The appliance is not switched on.
There is no voltage in the mains
socket (try to connect another ap-
pliance into it).
Wait some hours and then check the
temperature again. Next time insert
smaller quantities of food to be fro-
zen at any one time.
Allow food to cool to room tempera-
ture before storing.
Place the products in a way so that
cold air could circulate among them.
Try to not open the lid often.
Do not leave the lid open longer than
necessary.
Set a warmer temperature.
Connect the mains plug properly.
Try connecting another electrical de-
vice to the power outlet.
Switch on the appliance.
Call an electrician.
2. Replace the lamp with one of the same
power and specifically designed for house-
hold appliances. (the maximum power is
shown on the lamp cover)
3. Connect the mains plug to the mains sock-
et.
4. Open the lid. Make sure that the lamp
comes on.
Solution
19