Siemens SITRANS MASS 2100 Compact Operating Instructions page 31

Location of DIP switch
The DIP switch is located in the electronic as shown below.
DIP switch settings for communication set-up
DIP switch Com‐
munication set-up
EOL active
EOL not active
NOTICE
Avoid DIP switch settings not mentioned in the table
DIP switch settings not mentioned in the table preceding are not allowed and may reduce
communication interface reliability.
Improper handling
The sensor connected to this device can be operated with high pressure and corrosive media.
Therefore improper handling of the device can lead to serious injuries and/or considerable
material damage.
● Only use cables with at least the same degree of protection as the sensor to install the
sensor.
It is recommended to use cables supplied by Siemens.
● Siemens supplied cables can be ordered with M12 plug on both ends or without plug.
● To guarantee the IP67 degree of protection, ensure that both ends of the cables are given
equivalent protection from ingress of moisture.
● For further information on Siemens-supplied cables, see Technical data (Page 47).
SITRANS MASS 2100 & FC300 (FCT010)
Compact Operating Instructions, 05/2020, A5E40504094-AB
Switch 1
On
On
WARNING
4.2 Connecting MASS 2100/FC300
Switch 2 Switch 3
On On
On Off
Connecting
Switch 4
On
Off
31