Table of Contents
Advertisement
4.2
Default settings
The functions that are available by setting the parameters are mostly disabled by default, as they need to be set based on the specific application.
Set the set point, differential, minimum and maximum output
Digital input ID1
Two circuit
Cut-off
Input B1
Input B2
Input B3
Digital input ID1
Output in the event of alarms
Direct/Reverse control mode
Slave mode
Speed-up
Output saturation
Outside temperature compensation (feedforward)
PI control
Phase control function
Output ramp
Output linearisation
Code +030220391 – rel 1.1 07/11/06
by trimmer (modifiable by dipswitch)
external alarm (modifiable by dipswitch)
inactive (modifiable by dipswitch)
inactive (modifiable by dipswitch)
Ratiometric pressure probe
Ratiometric pressure probe
NTC temperature probe 10kΩ
Normally closed
100%
Direct
inactive
active (duration 2 sec)
inactive
inactive
inactive
short impulse
1 s
active
12
FCP manual
Table 4.e
Advertisement
Table of Contents
