SOMFY Wirefree Roll-Up 28 RTS Quick Programming Manual

BEFORE YOU BEGIN: Check if you have a paired remote with the following directions:
1) Supply power to the motor by connecting the power source to the power cable on the motor.
2) If a remote was ordered, press a directional button (UP or DOWN) and see if the shade operates. If a multi-channel
remote was ordered, select the channel the shade should be programmed under then operate the shade.
a) If the shade operates - the shade is already programmed.
b) If the shade does not operate - choose the channel on which you would like to control the shade. PRESS & HOLD
the PROGRAMMING BUTTON on the motor until it jogs once. Then BRIEFLY PRESS the PROGRAMMING BUTTON
on the remote. The shade will jog once. The shade is now programmed.
NOTE: Upper and lower limits are set at the factory. In the event limit setting is required, please follow
steps under Initial Programming and Limit Setting.
INITIAL PROGRAMMING AND LIMIT SETTING
NOTE: Motor will exit programming mode after 2 minutes of inactivity. While in programming
mode, the shade only operates when UP or DOWN buttons are continuosly pressed.
Step 1:
To initiate programming PRESS
& HOLD the UP and DOWN buttons at the
same time until the shade jogs.
If the shade raises instead of closing, change the direction - PRESS & HOLD the MY/
STOP button until the shade jogs. Confirm correct direction of operation before proceeding.
Step 3:
Bring the shade to your desired upper
limit. PRESS & HOLD both the MY/STOP and
DOWN buttons until the shade begins to move
down, then release. Stop the shade at the desired
lower limit, adjust by pressing the UP or DOWN.
Step 5:
PRESS & HOLD
the MY/STOP button until
the shade jogs to confirm
both limit settings.
Copyright © Somfy SAS 5/2019
Roll-Up 28 Wirefree™ RTS
Quick Programming Guide
Step 2:
Check the direction of
operation. Press the DOWN button
and confirm the shade lowers.
Step 4:
PRESS & HOLD the UP
and MY/STOP buttons until the
shade begins to move up.
The shade will stop at the original
upper limit. Adjust if necessary.
Step 6:
To finalize BRIEFLY PRESS the PROGRAMMING
BUTTON on the back of the control. The shade will jog and
will now operate in user mode. A brief press of the UP or
DOWN button will send the shade to the respective limit.
Programming
Button
ADJUSTING THE LIMITS IN USER MODE
UPPER LIMIT
Step 1:
wish to adjust and let it stop.

Step 2:
simultaneously until the shade jogs, then release.

Step 3:
DOWN buttons.
Step 4:
shade jogs, then release. Check the new limit.
P-0039CBG
LOWER LIMIT
Move the shade to the current limit position you
PRESS & HOLD both UP and DOWN buttons
Adjust to a new limit position using the UP or
PRESS & HOLD the MY/STOP button until the