Figure 4-1: Shuttle Knob - Ametek CS Series User Manual

User Manual – Rev J
4.1.4 The Shuttle Knob
The shuttle knob is located to the right of the LCD screen and is used to change setup
parameters. Note that it cannot be used to move the cursor position between menu fields. Use
the UP and DOWN arrow keys for this.
The shuttle knob can operate in one of two distinct modes of operation:
MODE
IMMEDIATE mode
SET mode
California Instruments
Counter
Clock
wise
DECR

Figure 4-1: Shuttle Knob

DESCRIPTION
Any time the ENTER key is pressed, the CS Series returns to
its normal mode of operation. In this mode, changes made with
the shuttle knob will take immediate effect. The IMMEDIATE
mode is useful for slewing output values such as current and
frequency and observing the effect on the load.
When the Set key is pressed again while the PROGRAM
screen is already displayed, changes made with the shuttle to
any output parameter will not take effect until the ENTER key is
pressed. In this mode, any changes made to a setup menu will
have a blinking cursor to indicate the pending change
condition. This mode allows changes to be made to all output
parameters and executing them all at once by pressing the
ENTER key.
Clock
wise
INCR
CS Series
51