Front Panel Controls - Ametek CS Series User Manual

User Manual – Rev J
Parameter
Altitude:
Relative Humidity:
Vibration:
Shock:
2.4

Front Panel Controls

Controls:
Shuttle knob:
Up/down arrow keys:
Function keys:
Displays:
LCD graphics display:
Status indicators:
California Instruments
Specification
< 2000 meters
< 6000 feet
0-95 % RAH, non-condensing maximum for temperatures up to 31°C
decreasing linearly to 50% at 40°C.
Indoor Use Only
Designed to meet NSTA project 1A transportation levels.
Designed to meet NSTA project 1A transportation levels.
The shuttle knob may be used to adjust current and frequency for
selected phase or all three phases while in the SET menu. In all other
menus, the shuttle may be used to change parameter values and
settings.
A set of up and down arrow keys is used to move the cursor position in
all menus. This allows quick selection of the desired function or
parameter.
Set key will show output voltage and frequency setting.
Meas key displays the measurement screens. Measure key will display
measurement values for selected phase or phase A if all three phases
are selected.
Menu key selects main menu.
Enter key is used to confirm selections.
Back key is used to back up to previous screen.
Output on/off key for output relay control.
Phase key toggles between phase A, B, C or all phases selection.
Keypad is used to enter numeric values without using the shuttle knob.
Large high contrast backlit LCD display. An adjustable viewing angle
makes it easy to read from all practical locations.
Large and bright status indicators inform the user of important power
source conditions.
The Remote lamp informs the user that the unit is under remote control.
The Overvoltage lamp indicates that excessive compliance voltage is
present at the output.
The Over temperature lamp illuminates when internal heat sink
temperatures are too high.
The Hi Range indicator is lit any time the unit is switched to the high
current range.
The Output On/Off indicator is on when the power source output relays
are closed.
The Phase A, B and C indicators are lit when the relevant phase is
selected with the Phase key.
CS Series
23