Table 3-9: Rj45 Lan Connector Pin Out - Ametek CS Series User Manual

User Manual – Rev J
3.6.8 LAN Interface – RJ45
An optonal RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control. A
standard RJ45 UTP patch cord between the AC Source and a network Hub may be used to
connect the AC source to a LAN. For direct connection to a PC LAN card, a crossover RJ45
cable is required. Consult your network administrator for directions on connecting the AC source
to any corporate LAN.
If the –LAN Ethernet interface option is present, the MAC Address (Media Access Control) of the
Ethernet port is printed on the serial tag of the power source. The serial tag is located on the
rear panel of the unit.
For information on how to set up a network connection or a direct PC connection using the LAN
interface, refer to the CS Series Programming Manual P/N 7004-988 distributed in Adobe PDF
format on CD ROM CIC496.
Pin # Ethernet TPE
10BaseT/100BastT/1000BaseT
1 Transmit/Receive Data 0 +
2 Transmit/Receive Data 0 -
3 Transmit/Receive Data 1 +
4 Transmit/Receive Data 2 +
5 Transmit/Receive Data 2 -
6 Transmit/Receive Data 1 -
7 Transmit/Receive Data 3 +
8 Transmit/Receive Data 3 -
California Instruments
LAN
EIA/TIA 568A
White with green stripe
Green with white stripe or
solid green
White with orange stripe
Blue with white stripe or
solid blue
White with blue stripe
Orange with white stripe
or solid orange
White with brown strip or
solid brown
Brown with white stripe or
solid brown.

Table 3-9: RJ45 LAN Connector pin out.

CS Series
EIA/TIA 568B
Crossover
White with orange stripe
Orange with white stripe or
solid orange
White with green stripe
Blue with white stripe or
solid blue
White with blue stripe
Green with white stripe or
solid
White with brown strip or
solid brown
Brown with white stripe or
solid brown
41