Advertisement
08
WARNING: During the Reset Procedure, the table lift will retract 7mm below the lowest normal operating height.
Please ensure that no obstacles impede this motion of travel.
1. Move the desk frame to the lowest position. (If there is "RST" displayed on the remote,
continue to step 3).
2. To initiate the Reset Procedure, press and hold the down button on the remote until "RST" is
displayed. Release the down button.
3. Press and hold the down button on the remote, the desk frame will begin to retract 7mm lower
than the lowest normal operating height. Continue to hold the down button until the frame rises
slightly and comes to a stop at the normal lowest position. To stop motion at any time, release
the down button.
4. Once the desk frame has completed the Reset Procedure, the desk height will be displayed
on the remote.
"
"
▲
Up button, adjust the desk upwards. Press and hold to continue travel.
●
"
"
▼
●
Down button, adjust the desk downwards. Press and hold to continue travel.
"1"
Position 1, user's first stored height position. Press once and desk will travel to the saved position.
●
"2"
Position 2, user's second stored height position. Press once and desk will travel to the saved position.
●
"3"
Position 3, user's third stored height position. Press once and desk will travel to saved position.
●
"4"
Position 4, user's fourth stored height position. Press once and desk will travel to the saved position.
●
"M"
Memory set position key. Press once followed by pressing 1, 2, 3, or 4 to save current height position.
●
Setting the LED display
Using the wired smart remote, retract the table lift to the lowest position. Press
and hold the 'Down' button again until the LED display flashes "RST".
Press and hold the 'M' button until the LED display flashes the starting height (if
the display returns to "RST" before the next step, repeat this step).
To change the value of the starting height, use the 'Up', 'Down' to increase and
decrease by 0.1. Use the '1', '2' to increase and decrease by 1s. Use the '3', and
'4' buttons to increase or decrease by 10s.
Once the correct value is displayed, wait 5 seconds until the LED display
flashes "RST". Follow the Reset Procedure outlined in the above section to save
the new starting height.
Note: the LED display has a tolerance of ±0.1.
Reset Procedure
Operation
Advertisement
