Advertisement
07
STEP 7
Secure desk frame & remote to tabletop
STEP 8
Secure center rails
STEP 9
Install control box & connect all peripherals
Line up the remote (8) with the tabletop
edge and install it to the tabletop using
a power drill and 2 wood screws (15).
• Plug in power cord (9) to AC.
• Plug in nearest leg (1) to M1.
Use extension cord (10) if
needed.
AC
M1
• Plug in remote (8) to HS.
• Plug in nearest leg (1) to M2.
Use extension cord (10) if
needed.
F
HS
M2
Assembly
Progressive Desk Tabletop
If you have a Progressive Desk tabletop, use the
machine screws (18) included in the tabletop
packaging. Line up the desk frame with the pre-
drilled holes on the underside of the tabletop and
insert all machine screw before using the Allen
wrench to tighten each machine screw (18).
Third-Party Tabletop
If you have your own tabletop, position the desk
frame so that the tabletop extends 1.5" beyond
the side brackets (6). Use a power drill to install 7
wood screws (14) into the hole positions.
Use the Allen wrench to secure both center
rails (5) using 8 machine screws (11). The
machine screws should be tightened
against the center rails.
Slide the control box (7) into frame end CB (4).
Attach both legs (1) to the control box (7). Use
the included extension cable (10) if necessary.
Attach remote (8) to control box (7).
Attach power cord (9) to control box (7).
Use the included self-adhesive cable ties (16)
to secure loose wires to the underside of your
tabletop.
We recommend having two people for this
step. Flip the fully assembled desk by the legs
(not
by
the
tabletop).
installed glides on the feet (2) as needed.
It is required to complete the reset procedure
in the next section prior to operating your
standing desk.
Adjust
the
pre-
Advertisement
