Development Kit User Guide
Rev 2.0 Apr.20
Antenna Connection
The RF SMA connector is used to connect an external antenna for the XS1110
module.
Figure 3-2: RF SMA Connector
Table 3-2: Antenna Connector Details
Component
RF SMA Connector
SYSTEM0
The SYSTEM0 header is used to set whether transmissions are done via UART
or I2C.
Figure 3-3: SYSTEM0 Header
Table 3-3: SYSTEM0 Details
Component
2-pin header
To set transmission selection to UART, disconnect jumper on SYSTEM0 for
SYSTEM0 pins to pull high (default).
8
PCB Label
Description
SMA1
External antenna connector for the XS1110
module
PCB Label
Description
•
P20
Transmission selection (UART or I2C)
•
SYSTEM0 : 0=I2C ; 1=UART
41113415