Anchor Outdoor Unit - CANVAC T-Series Installation Manual

OUTDOOR UNIT INSTALLATION
Outdoor Unit Dimensions (mm)
W x H x D
800x554x333 (31.5"x21.8"x13.1")
If the unit will be installed on the ground or on a concrete mounting platform, a
landing stand must be used, proceed as follows:
1. Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
6. Remove the nuts from expansion bolts, and
place the outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.
9. Be mindful of potential snow depth, the out-
door section must be placed at a height that
ensures that snow cannot cover it.
WARNING!
WHEN DRILLING INTO CONCRETE, EYE PROTECTION
IS RECOMMENDED AT ALL TIMES.
Mounting Dimensions
Distance A (mm) Distance B (mm)
514 (20.24") 340 (13.39")
54
EN