Indoor Unit Installation; Select Installation Location - CANVAC T-Series Installation Manual

INDOOR UNIT INSTALLATION

INSTALLATION INSTRUCTIONS
PRIOR TO INSTALLATION
Before installing the indoor unit, refer to the label on the
product box to make sure that the model number of the
indoor unit matches the model number of the outdoor unit.
STEP 1: SELECT INSTALLATION LOCATION
Before installing the indoor unit, you must choose an appro-
priate location. The following are standards that will help you
choose an appropriate location for the unit.
DO NOT INSTALL UNIT IN THE FOLLOWING
LOCATIONS:
Near any source of heat, steam, or combustible gas
Near flammable items such as curtains or clothing
Near any obstacle that might block air circulation
Near the doorway
In a location subject to direct sunlight
NOTE ABOUT WALL HOLE:
If there is no fixed refrigerant piping:
While choosing a location, be aware that you should leave ample room for a wall hole (see Drill wall hole for connective piping
step) for the signal cable and refrigerant piping that connect the indoor and outdoor units. The default position for all piping is the
right side of the indoor unit (while facing the unit). However, the unit can accommodate piping to both the left and right sides.
PROPER INSTALLATION LOCATIONS MEET
THE FOLLOWING STANDARDS:
• Good air circulation
• Convenient drainage
• Noise from the unit will not disturb other people
• Firm and solid—the location will not vibrate
• Strong enough to support the weight of the unit
• A location at least one meter from all other electrical
devices (e.g., TV, radio, computer)
43
EN