DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide
Power Failure (AC Power)
In the event of a power failure, just as a precaution, unplug the power cord from the Switch. After the power returns,
plug the power cord back into the power socket of the Switch.
Installing Power Cord Retainer
To prevent accidental removal of the AC power cord, it is recommended to install the power cord retainer together with
the power cord.
NOTE: The DGS-3630-28PC and DGS-3630-52PC do not support the installation of the power cord
retainer.
1. With the rough side facing down, insert the tie wrap into the hole below the power socket.
2. Plug the AC power cord into the power socket of the Switch.
3. Slide the retainer through the tie wrap until the end of the cord.
Figure 3-5 Insert Tie Wrap into the Switch
Figure 3-6 Connect the power cord to the Switch
29