Side Panel Components; Dgs-3630-52Pc Switch; Front Panel Components; Led Indicators - D-Link DGS-3630 Series Hardware Installation Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide

Side Panel Components

The side panels of this switch contain heat vents, fans, and rack-mounting screw holes. The heat vents are used to
dissipate internal heat and facilitate internal air circulation. Do not block these openings. Leave at least 4 inches of
space at the sides of the Switch for proper ventilation. Without proper heat dissipation and air circulation, system
components might overheat which could lead to system failure or even severely damaged components.

DGS-3630-52PC Switch

Front Panel Components

The front panel of DGS-3630-52PC features a variety of LED indicators, ports and a Mode button.
Ports that can be found on the front panel of this switch are listed in the table below.
Port
10/100/1000 Mbps RJ45 PoE
Ports
Combo RJ45 PoE/SFP Ports
10 Gigabit SFP+ Ports
For a complete list of SFP/SFP+ transceivers that are compatible with this switch, refer to the SFP Ports and SFP+
Ports sections in Appendix A - Technical Specifications.

LED Indicators

Located on the front panel of this switch are LED indicators: Power, Console, RPS, Fan Err, Link/Act and PoE
indicators for all the ports, Link/Act and PoE indicators for mode selection, and Stack ID.
Figure 2-16 Side panels of the DGS-3630-52TC
Figure 2-17 Front panel view of the DGS-3630-52PC
Description
The Switch is equipped with 44 RJ45 PoE Ethernet ports. These ports can operate
at 10 Mbps, 100 Mbps, and 1 Gbps wire-speeds.
The Switch is equipped with 4 combo ports that can either operate as RJ45 PoE
Ethernet ports or SFP ports. The RJ45 ports can operate at 10 Mbps, 100 Mbps,
and 1 Gbps wire-speeds. The SFP ports can operate at 100 Mbps and 1 Gbps
wire-speeds and support a wide collection of SFP transceivers.
The Switch is equipped with 4 SFP/SFP+ ports. These ports can operate at 1
Gbps and 10 Gbps wire-speeds and support a wide collection of SFP/SFP+
transceivers.
22