Dgs-3630-52Tc Switch; Front Panel Components; Led Indicators - D-Link DGS-3630 Series Hardware Installation Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Hardware Installation Guide

DGS-3630-52TC Switch

Front Panel Components

The front panel of DGS-3630-52TC features a variety of LED indicators and ports.
Ports that can be found on the front panel of this switch are listed in the table below.
Port
10/100/1000 Mbps RJ45
Ports
Combo RJ45/SFP Ports
10 Gigabit SFP+ Ports
For a complete list of SFP/SFP+ transceivers that are compatible with this switch, refer to the SFP Ports and SFP+
Ports sections in Appendix A - Technical Specifications.

LED Indicators

Located on the front panel of this switch are LED indicators: Power, Console, RPS, Fan Err, Link/Act indicators for all
the ports, and Stack ID.
Figure 2-12 Side panels of the DGS-3630-28PC
Figure 2-13 Front panel view of the DGS-3630-52TC
Description
The Switch is equipped with 44 RJ45 Ethernet ports. These ports can operate at
10 Mbps, 100 Mbps, and 1 Gbps wire-speeds.
The Switch is equipped with 4 combo ports that can either operate as RJ45 Ethernet
ports or SFP ports. The RJ45 ports can operate at 10 Mbps, 100 Mbps, and 1
Gbps wire-speeds. The SFP ports can operate at 100 Mbps and 1 Gbps wire-
speeds and support a wide collection of SFP transceivers.
The Switch is equipped with 4 SFP/SFP+ ports. These ports can operate at 1
Gbps and 10 Gbps wire-speeds and support a wide collection of SFP/SFP+
transceivers.
Figure 2-14 LED indicators for the DGS-3630-52TC
19