Maintenance - HAMPTON BAY MTVS2500S Use And Care Manual

Maintenance

1
Removing the access panels
NOTE: This fireplace insert uses two clear 120 Volt, 40 Watt,
E-12 socket base light bulbs (small base, chandelier candle
type bulbs). The light bulbs are located at the bottom of the
unit. You can change the light bulbs from the back of the
firebox. For convenience, if one of the light bulbs burns out, it
may be easier to replace all of the light bulbs at the
same time.
□ Turn the firebox master power "on/off" switch to the "off"
position, (located behind the front access panel).
□ Pull the mantel away from the wall, as you need to access
the back of the firebox. Unplug the firebox from the power
outlet.
□ Let the firebox insert cool if it has been operating.
□ Looking at the back of the firebox, locate the small access
panel.
□ Remove the screws in the panel using a Phillips or flathead
screwdriver. Pull the access panel toward you. The light
bulbs are attached to a slide, which will bring them to the
edge of the firebox for your convenience.
ACCESS PANEL
2
Replacing the bulbs
WarNING: Do not exceed 40 Watts per bulb. Use of
higher rated light bulbs may cause overheating and result
in a fire, causing property damage, personal injury, or loss
of life.
□ Carefully remove the burnt light bulb. This may require
holding the light socket with one hand while unscrewing
the light bulb with the other hand.
□ Install the new light bulbs.
□ Push in the slides and replace the access panel.
□ Insert and tighten the screws in the panel that were
removed.
□ Plug the firebox into the power outlet and return your
mantel to its original position against the wall.
□ Turn the firebox master power "on/off" switch to the "on"
position and press the power button (1) on the control
panel (T). Check that the replacement bulbs are working.
15
Please contact 1-877-527-0313 for further assistance.
HAMPTONBAY.COM