Chapter 6 - Troubleshooting; Introduction; General Troubleshooting - CareFusion Alaris 8600 Technical & Service Manual

CauTIOn
Class devices are safe under reasonably
1 LED
foreseeable conditions of operation, including the
use of optical instruments for intrabeam viewing.
To avoid potential harm, avoid looking into the
beam.
Chapter 6 – Troubleshooting
6.1

InTrOduCTIOn

This chapter contains possible technical
problems that can occur while using the
Auto-ID Module. See this chapter before
attempting to service the Auto-ID Module.
Refer to the PC Unit/Pump Module
Technical Service Manual for Alaris
information.
Use the information in this chapter to help
diagnose and correct technical problems.
Use the applicable maintenance software to
perform required tests.
6.2

General TrOuBleShOOTInG

For the Alaris
®
with the Auto-ID Module:
nOTe: The PC Unit will not recognize
the Auto-ID Module if the software and
Communications Interface Board (CIB) are
not compatible.
• Auto-ID Module software must be
or later. Auto-ID Module, PC
8.5.26.0
Unit and Wireless Main software must be
compatible (see Table
• Model :
8000
compatible (see Figure
• Default parsing rules (Auto-ID settings
configured on PC Unit) must be set (using
applicable maintenance software) to
translate patient or clinician
Once settings are configured, IDs can
be scanned to verify proper operation,
even without a pumping module being
attached.
System to function properly
).
6-1
must be bar code
CIB
).
6-1
bar codes.
ID
Alaris Auto-ID Module
®
Technical Service Manual
System
®
6-1