TEFAL IH2018 Manual page 9

• Always plug the appliance into a dedicated socket outlet with an earth
connection. Do not use a socket adaptor or connect any other appliance
into the same socket simultaneously, to avoid electrical overloading and
risk of fire.
• Given the diverse standards in effect, if the appliance is used in a
country other than that in which it is purchased, have it checked by an
Approved Service Centre.
• Remove all packaging materials, stickers and accessories from inside
and outside of the appliance.
• The appliance must be placed and used on a flat, stable, heat-resistant
work surface, away from water splashes.
• Do not place or use this appliance in high humidity environments.
• Do not place or use the induction plate on steel or aluminium surfaces.
• Maintain a gap of at least 10cm (4 inches) on all sides of the appliance
to ensure adequate ventilation.
• Never place or use the appliance close to a wall or below a wall cupboard.
• Never place or use the appliance below or close to easily inflammable
objects (e.g. curtains, etc.).
• Never place or use the appliance on or close to a cooking hob or other
sources of heat.
• Unwind the power cord fully before use.
• Do not use an extension lead. If you accept liability for doing so, only
use an extension lead which is in good condition, has a plug with an earth
connection and is suited to the power rating of the appliance.
• Never leave the appliance unattended whilst connected to the power
supply, even if for a few moments, especially where children are present.
• Do not let the power cord hang where children may reach it.
• The power cord must never be close to or in contact with hot parts of the
appliance, close to sources of heat or resting on sharp edges.
• Take all necessary precautions to prevent anyone tripping over an
extension cord.
• Switch off and disconnect the appliance from the power supply when
not in use.
• Never disconnect the plug by pulling on the power cord.
• Inspect the appliance and power cord for signs of wear or damage prior
to connecting to the power supply.
EN
9