Fry Mode - TEFAL IH2018 Manual

FRY Mode

• This mode fries food in a large quantity of oil - maximum 2 L (-13).
• Below are the power levels and oil temperatures that correspond to
each program:
P1 P2
1200 W 1200 W
100 °C 120 °C
• The timer is available in Fry Mode:
Default time
15 min
CLEANING
You must disconnect the power lead, wait until the ceramic glass plate
has cooled, then follow the instructions below to clean the appliance:
1. Ceramic glass plate: if the ceramic glass plate is very dirty, clean
using a damp non-abrasive sponge or for more stubborn stains use an
appropriate cleaning product which is designed for use on ceramic hobs.
2. Cooker body and control panel: Use a damp soft cloth to clean. In case
of any oil stains that are not easily removed, wipe away the stains with
a soft cloth rinsed in warm water and a little washing-up liquid and then
clean using a damp soft cloth.
3. Air entry/air exit surface: remove any dust with a cotton bud.
ERROR CODES
• Receptacle missing or not the correct type:
If the pot base diameter is less than 10 cm or if the pot material is
unsuitable, the buzzer will sound and the digital display shows "E1".
Change the cookware.
• Protection of the power source against overheating:
If the power source overheats, the induction cooking appliance cuts
off the incoming power supply and the screen displays "E2". Allow the
hotplate to cool: if the defect persists, please contact the customer service.
• Over or under- voltage protection:
If the voltage is greater than 265 V - 285 V, the incoming power supply for
P3 P4
1400 W 1400 W
140 °C 160 °C
P5 P6
1600 W 1800 W
180 °C 200 °C
Maximum time
180 min
EN
P7
2100 W
220 °C
15