Installing The Main Unit - Clarion VX401 Owner's Manual & Installation Manual

5. Installing the Main Unit

This unit is designed for fixed installation in the
dashboard.
1. When installing the main unit in NISSAN
vehicles, use the parts attached to the unit
and follow the instructions in Figure 6.
When installing the main unit in TOYOTA
vehicles, use the parts attached to the
Mounting Screw Holes (Side View of the Main Unit)
For NISSAN vehicle
Installing the Main Unit in NISSAN Vehicle
Trim ring
Note:
* 1: Position the face panel with its wide edge at the
bottom. Fit the edge into the groove of the main unit.
. Wire as shown in Section 7.
. Reassemble and secure the unit in the
Figure 5
Main Unit
Mounting bracket
(1 pair for the left and right sides)
Figure 6
vehicle and follow the instructions in
Figure 7.
dashboard and set the face panel and center
panel.
For TOYOTA vehicle
6- Spacer (thickness: 1mm)
6-Spacer (thickness: 1 mm)
6-Flat head screw
6- Flat head screws
(M5x8)
(M5
(Attached to the main unit)
(attached to the main unit)
8)
49
VX401/VZ401