W-NXS AND CP-NXS
Maintenance
Tools needed when opening and working in the NXS include the following:
Front cover and top cover plates: Torx T8 driver
•
Hard disk mounting: Torx T10 driver
•
Protective earth terminal: Phillips-head driver
•
Spacing bolts for PC/104 cards: 7/32" hex socket/nut driver, 5mm (hex) socket/nut driver
•
Remove power from the NXS before beginning any maintenance.
Note
As needed, use the following procedures to perform maintenance tasks on the NXS controller:
•
•
page 22
•
•
•
•
•
Open the device (front panel)
The NXS contains electronic components that are vulnerable to static discharge. Therefore, take
Caution
precautionary measures before opening the device. See
Procedure 4
To open the NXS front panel
Step 1
Remove the six Torx T8 screws, setting them aside.
Step 2
Remove the front panel.
To close the device, simply realign the front panel on the frame, and refasten the six Torx T8 screws.
Note
74-4059-01
page 20
page 21
page 25
page 27
page 28
page 29
20
"Static Discharge Precautions,"
page 5.